Bang & Olufsen BeoLink 1703 - Add Event; Add Command

Set up BeoLink Gateway - Macros - Macro Programming 34
Add event
The
Add event
button is used to add the two buttons (see above) that can be used to set the cinema scene. See “Resource Event” page 35.
Capture
When activating the
Capture
button and next activating the physical wall button and the virtual button on the user interface, there will be created
the two events in the event-part of the display.
Add command
The
Add command
button is used to dene the commands to be executed when either of the two buttons in the above example are pressed. With
both events the ‘Set Cinema Scene’ resource in the home automation system is executed to avoid an endless loop. See “Resource Command”
page 36.