Cable connections 18
Cable connections
- Connect the Ethernet socket using a
Network Link Product Cable to the
B&O Recommended Router or to the
ISP Router/switch, see page 13.
[See BeoLink Handbook regarding
Active Infrastructure - Network Setup
and regarding appropriate cables].
- Connect the Master Link cable from
the installation to the ML socket.
[See BeoLink Handbook for
appropriate cables].
- Connect the RS232 cable to RS232
based system(s) or to a powered USB
hub that connects to RS232 based
systems.
[The USB to RS232 cable converter
has Bang & Olufsen Part No.:
6100051].
- Mount mains cable in the wire holder as illustrated.
- Mount BeoLink Gateway in the rack system, wall bracket or place it on a stable surface.
Now BeoLink Gateway is ready for setup.
USB
(RS232)
Network
Link
via
Router/
Switch
Mains
Power
Master
Link
To Next Page
Loading...