Bang & Olufsen BeoLink 1703 - Cameras; Remove a Camera; Camera Access; Camera Resources Path

Set up BeoLink Gateway - Interfaces - Cameras 45
Cameras
In this section the conguration
for several network cameras can
be added.
Adding a camera, press the
+
in
the
Cameras +
.
Remove a camera
If a camera is to be removed
from the list, choose the camera
in the left column and press the
Remove
button.
Camera access
Fill in data as follows:
- The Name eld is lled in with a
name that identies the camera.
The name will be shown in the
user interfaces.
- In the drop down list for Zone,
select the zone in which the
camera is placed.
- A Base URL (that is the URL +
port No., to get in contact to the
camera) to which all commands
will be appended must be
provided. The format may vary, e.g. http://192.168.1.37:80.
- The optional User name and Password elds may be used for basic HTTP authentication to access the camera from the user interfaces.
Camera resources path
Commands for obtaining Video & Images both in high and low resolution must be provided, e.g. mjpg/video.cgi for high resolution video.
All the commands will be appended to the base URL.
Note: The two top lines regards images and the two lower lines regards video streaming.
All four lines must be lled in for video streaming.
See tip in BeoWise > Link > BeoLink > BeoLink Gateway > TIPS > Supported IP cameras.
Note: The BeoLink Gateway is not supporting the H.264 format in cameras.