Set up BeoLink Gateway - Setup - Integration Protocol - over Ethernet 24
Integration Protocol - over Ethernet
The Home Integration
Protocol - Over Ethernet
(upper part of the page) is
intended for later use.
The MasterLink Gateway
Protocol - Over Ethernet
(lower part of the page) makes it
possible for hand held devices
and home automation
controllers (other devices) to
interact with the BeoLink
Gateway.
The Integration protocol can be
enabled on the local network
(Ethernet), as well as on the
RS232 port.
Note! To be able to use the
BeoLink App the Integration
protocol must be enabled on the
local network.
TCP port
For the LAN a TCP port must be allocated. The default port is 9000. Ports below 1024 are reserved for standard TCP services.
Enabled
With a checkmark set in
Enabled the integration protocol (TCP protocol over Ethernet) is enabled.
Requires authentication
Authentication is optional.
Authentication is required if
Enabled is chosen and if the
Requires authentication is chosen.
Consequently user name and password must be given when connecting to each system.
Disabled
It could be necessary to disable the function if a controller connected to the BeoLink Gateway does not support authentication.
To Next Page
Loading...