Bang & Olufsen BeoLink 1703 - Home Automation Systems Supported - Connection Types

Home Automation systems supported 16
Home Automation systems supported - connection types
The below table gives an instant overview - as per date while writing - of systems supported and their connection type.
See BeoWise > 3rd party products > Home Automation for an up-to-date list of supported systems.
Home Automation system drivers Ethernet connection RS232 connection RS485 connection
Clipsal +
Conson Concept XP (converter from RS485 to RS232 is needed) +
Custom Strings + +
Dynalite +
KNX (EIB KNX, Busch Jaeger) +
KNX (FT 1.2, PEI-IOmode) +
KNXnet (IP tunneling) +
Legrand Bticino +
LK IHC (Intelligent House Control, Viewer models only, LexControl) +
Lutron: Grak Eye (GRX), Grak QS (QSE), Radio RA + +
Lutron: Home Works, Home Works QS, Home Works Radio Ra2, +
Lutron Home Works Interactive +
Phillips Hue +
Smart House + +
Vantage + +
Velux + +
Home Automation Control systems * Ethernet connection RS232 connection RS485 connection
Crestron + +
AMX + +
Control4 + +
Beckhoff + +
! Do not use RS232 cables that exceed 10 metres. Cable length of 2 to 5 metre is recommended.
Use the Help function in the BeoLink Gateway Setup > System regarding details on the BeoLink products and individual home automation
systems.
* Drivers are available on www://mlgw.bang-olufsen.dk/drivers.html and does not support two way status from Network Link Prodducts.