3. Display installation
To remove the pin:
1. Position the display with its rear side facing you.
2. While holding the display panel pushed down, pull out the red pin in the display stand.
3. Keep the pin in the dedicated hole in case the display needs to be shipped later.
To retain the pin for possible future transportation, insert the short, red end of the pin
back into the stand of your display.
3.4 Adjusting the disp lay position
In the factory, the height-positioning and the tilt system in the display stand are locked
with red pins to prevent damage during transportation. You’ll have to remove both pins
before adjusting your display posit
ion.
To ad just the display position
1. Remove the tilt lock pin, see "Unlocking the tilt mechanism", page 10.
2. Remove the height lock pin in the display stand, see "Unlocking the height mechanism", page 10.
3. Tilt, swivel, raise and lower the disp
lay as desired.
K5902079 CORONIS UNITI 21/04/2015
11
To Next Page
Loading...
