5. Advanced operation
5.4 Key indicator lights
About the key indicator lights
By default, after lighting up, the key indicator lights will dim again if no further actions are taken within the
following 5 seconds. However, this behavior can be changed so that the key indicator lights are always
on or always off.
To configure the key indicator lights
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Indicator Lights menu.
3. Enter the Keys submenu.
4. Select Automatic/Always On/Always Off as desired and confirm.
5.5 Power lock function
About the power lock function
By enabling the power lock function, the Coronis Uniti is forced to remain switched on. This means that it
can’t be switched to stand-by mode manually until the power lock function is d
isabled again.
To enable/disable the power lock function:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > User Interface > Controls menu.
3. Enter the Power Lock submenu.
4. Select Enabled/Disabled as desired and confirm.
5.6 SoftGlow Task light
About the SoftGlow Task light
The Coronis Uniti is equipped with a SoftGlow Task light. This allows you to have light on your desk in a
dark environment. The brightness of the SoftGlow Task light can be adjusted.
To enable/disable the SoftGlow Task light:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Lights menu.
3. Enter the SoftGlow Task light submenu.
4. Select Enabled/Disabled as desired and confirm.
To adjust the S oftGlow Task light brightness:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Lights menu.
3. Enter the SoftGlow Task light brightness submenu.
4. Set a SoftGlow Task light brightness value as desired and confirm.
30
K5902079 CORONIS UNITI 21/04/2015
To Next Page
Loading...
