EasyManua.ls Logo

Barco Coronis Uniti MDMC-12133 - Bringing up the OSD Menus; Navigating through the OSD Menus

Barco Coronis Uniti MDMC-12133
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Daily operation
To switch your display to Stand-by using the keys:
Switchingoffthedisplaycanbedoneby:
1. Push the standby key shortly for three times. After the second push, the OSD message “Power off”
appears on the display, this means the display will go in standby mode.
As a result, the display will switch to stand-by mode and the power status indicator light is orange.
In case of a power outage recovery, your display will always start-up in the power mode
it was in before the power interruption (i.e. stand-by or on). This protects your display
against inadvertent image retention problems.
4.4 Bringi ng up the OSD menus
How to bring up the OSD menus
TheOSDmenuallowsyoutocongure different settings to make your Coronis Uniti t your needs within
your working environment. Also, you can retrieve general information about your display and its current
conguration settings through the OSD menu.
Bringing up the OSD menus can be done by:
1. If not already done so, switch on the display as previously described.
2. Illuminate the keys as previously described.
3. While the keys are illuminated, touch the menu key.
As a result, the OSD main menu comes up in the bottom right corner of the screen. However, if no further
actions are taken within the following 90 seconds, the OSD will disappear again.
The OSD menu auto-exit function can be disab led in the OSD menu. Plea se refer to
"OSD menu automatic close function", page 29 for de tailed instructions on how to do
this.
4.5 Navigating th rough the OSD menus
How to navigate through t he OSD menus
Navigating through the OSD menus can be done by:
Use the left/right keys to move through the (sub)menus, change values or make selections.
To go into a submenu or conrm adjustments and selections, use the menu key.
Use the standby key to cancel adjustments or exit a (sub)menu.
Exit all OSD menus at once by touching the standby key for approximately 2 seconds.
The key icons are displayed above the keys, adapted to the function that it is used for
(menu dependent).
K5902079 CORONIS UNITI 21/04/2015 25

Table of Contents

Related product manuals