5. Advanced operation
4. Select one of the available versions and confirm.
To obtain full resolution (2100 x 2800) and full refresh rate (60Hz), DPCD V1.2 should be
selected.
5.26 EDID format
About EDID format
The Coronis Uniti supports two EDID formats: E-EDID V1.4 and DisplayID V1.3
To select the EDID format
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > > DisplayPort 1/2 > EDID menu.
3. Enter the EDID format submenu.
4. Select one of the available format and confirm.
5.27 EDID timings
About EDID t imings
Following EDID timings are available for your Coronis Uniti:
Refresh Rate Allows to manually select the refresh rate of the
image source video input signal depending on the
maximum refresh rate of the display controller
connected to your display.
Color Depth
Allows to change the color depth to 8 or to 10 bit.
To manually set EDID timings:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Image Sources > Input Settings > DisplayPort 1/2 menu.
3. Enter the EDID submenu.
4. Select Resolution, Refresh Rate, Preferred Orientation or Color Depth.
5. Select one of the available settings and confirm.
5.28 Display info
About display info
Your display serial number, color type, native resolution, firmware versions, etc. are available in a dedi-
cated submenu of the OSD menu.
To retrieve inf o about your display:
1. Bring up the OSD main menu.
2. Navigate to the About this Display menu to make the information visible on the screen.
42
K5902079 CORONIS UNITI 21/04/2015
To Next Page
Loading...
