5. Advanced operation
5.9 Hibernate
About hibernate
Enabling hibernation will not only switch off the backlight but will also force the display to disable other
functionalities so that power consumption is further reduced to a minimum. This happens after a specific
period of time which can be manually adjusted.
Hibernate can only be enabled on your display when the DPMS mode is enabled first.
Therefore, please refer to "DPMS mode", page 31 to do this.
To enable/disable hibernation on your display:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate submenu.
4. Select Enabled/Disabled as desired and confirm.
To specify the hibernate timeout:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > Power Management menu.
3. Enter the Hibernate Timeout submenu.
4. Set the timeout value as desired and confirm.
5.10 I-Lum inat e def a ult m ode
About th e I-Luminate default mode
The I-Luminate mode defines the default activated mode during the I-Luminate boost. This mode can be:
Screen
The boost mode is applied on the screen display.
Film (large or small) Film (large or small): the boost mode activates a
high illuminated rectangle on top of the screen,
simulating a light box for use with radiological film.
The size of this rectangle is similar to a classic
(large or small) radiological film.
To set the I-Luminate mode:
1. Bring up the OSD main menu.
2. Navigate to the Configuration > I-Luminate menu.
3. Enter the Default mode submenu.
4. Select Screen/Small Film/Large Film as desired and confirm.
32
K5902079 CORONIS UNITI 21/04/2015
To Next Page
Loading...
