3. Display installation
1. Drill four holes in the desk.
Fixation position: 4x M4
120
100
(143)
(100)
300
405
2. Fasten the foot on the desk with 4x M4 screws (length of the screws depending on the depth of the
desk).
3.11 VESA-mount installation
CAUTION: Use suitable mounting apparatus to avoid risk of injury.
WARNING: Never move a display att
ached to an arm by pulling or pushing the display
itself. Instead, make sure that the arm is equipped with a VESA approved handle and
use this to move the display.
Please refer to the instruction manual of the arm for more information and instructions.
WARNING: Use an arm that is approved by VESA (according to the VESA 200 x 100 mm
or VESA 100 x 100 mm standard).
Use an arm that can support the weight of the display. Refer to the technical specifica-
tions of this display for the applicable weight.
K5902079 CORONIS UNITI 21/04/2015 19
To Next Page
Loading...
