3. Display installation
CAUTION: You should mount the panel in landscape position. Portrait position is pos-
sible but not supported.
WARNING: To avoid muscle s train or ba ck injury, use lifting aids and proper lifting tech-
niques w hen removing or replacing.
Overview
The panel, standard attached to the tilt & swivel foot, is compatible with the VESA 200 x 100 mm and
VESA 100 x100 mm standard. So it can be used with an arm stand according to the VESA 200 x 100 mm
or VESA 100 x 100 mm standard.
Therefore, the tilt & swivel foot must be removed from the panel.
1. Fasten the height mechanism of the foot by putting the red pin in the hole "Unlocking the height mech-
anism", page 10.
2. Put the display face down on a clean and soft surface. Be careful not to damage the panel screen.
3. Loosen the plastic covers with a cross head screwdriver.
20 K5902079 CORONIS UNITI 21/04/2015
To Next Page
Loading...
