4. Lamp & Lamp House
CAUTION: Due to its high internal pressure, the lam p may explode in e ither hot or cold states if improperly
handled.
Necessary tools
10mm nut driver or flat screw driver.
How to remove t he Lamp House from the projector?
1. M ake sure the projector is switched off and c ooled down.
2. R emove the cover of the Lamp House compartment.
3. R elease the two retaining screws (reference 1 image 4-5) at the base of the Lamp House. Use a 10mm nut d river or a flat screw
driver.
4. R emov e the Lamp House as follows:
a) G rip the Lamp H ouse by the bottom handle and partially slide it out of the lamp com partment
b) G rip the Lam p House by both handles and remove it completely from the projector.
c) Place the Lamp House on a stable support.
Caution: Be aware of the weight of the lamp as semb ly. Tak e the necess ary pre cautions to avoid personal injury.
1
Image 4-5
This procedure is illustrated with a M otorized Lamp House. Nevertheless, the instructions are also applicable
for the manual Lamp House.
4.4 Removal of the x enon lamp from manual S/M Lamp Ho use
WARNING: DO NOT PER MIT UNAUTHORIZED PERSONNEL TO PERFORM OR ATTEMPT ANY PHASE OF
XENON LAM P HA NDLING OR SERVICE. ONLY TRAINED AND QUALIFIED TECHNICAL SERVICE PERSONNEL
ARE ALLOWED TO HANDLE THE XEN ON LAMP.
WARNING: This procedure may only be performed by qualified technical service p ersonnel.
30 R5905067 DPXK-19B/23B/P 17/09/2012
To Next Page
Loading...
Need help?
General