5. Removal and installation of projector covers
5. REMOVAL A ND INSTALLATION OF PR OJECTOR
COVERS
About this chapter
Most m aintenance and servicing procedures deman d removing one or more of the projector covers to gain access to the parts to
maintain or to service. To avoid redundancy, all p rocedures about cover removing or installing are grouped toge ther in this chapter.
The maintenance and servicing procedures also refer to this chapter if required. The pr ocedur
es in this chapter des cribe, with
detailed s tep by step actions and illustrations, how to r emov e or install the projector covers. Note that some covers may only be
removed by qualified service p ersonnel, see remarks above each procedure.
WARNING: Always switch off the projector and unplug t he power cord before removing one of t he covers,
unless otherwise stated.
Overview
• Removal of the lamp cover
• Removal of the input cover
• Removal of the front cover
• Removal of the side cover
• Removal of the rear cover
• Removal of the top cover
• Open the sealed co mpartment
• Close the sealed compa rtment
• Installation of the top cover
• Installation of the rear cover
• Installation of the s ide cover
• Installation of the front cover
• Installation of the input cover
R5905043 DP2K-12C/11CX 19/02/2018
77
To Next Page
Loading...
Need help?
General
