2. ICMP functionality
• Automation Cues: event cues that are triggered from different sources and to which can be assigned
actions to be executed by the automation engine.
• Verify internal clock of the ICMP.
All installation and maintenance operations on the ICMP are performed via Communi-
cator, the Barco configuration software. Please refer to the Communicator user guide
for further information.
About Default settings
The restore of factory setting is a feature that allows removing all settings performed on the ICMP and
replaces them with the default values set at the factory. Please refer to the Communicator user guide for
further information.
About the ICMP internal c lock
The crystal on the ICMP board that manages the clock shows a certain drift (all crystals do). With the
Communicator the internal clock can be adjusted. This maintenance action should be repeated every 3
months. When neglected the system will locks up.
From ICMP software version 1.2.1 onwards it is possible to enable NTP (Network Time Protocol). You
havetoconfigure (at installation) an IP address where the ICMP can find a sync signal. From then on,
and as long as the connection is active, the ICMP will automatically keep its clock correct. For detailed
instructions see user guide of the Communicator.
R5905722 ICMP 09/11/2016
27
To Next Page
Loading...
Need help?
General