3. ICMP installation
Image 3-4
3. Insert the HDD into the HDD slot. Ensure that the handle is sufficiently open so that the hook (reference
1) of the handle can pass the front plate of the ICMP.
1
Image 3-5
4. Push the HDD complet ely and firmly inside its slot, close the handle, and move the latch towards the
right.
Image 3-6
5. Switch on the projector.
In case you replace one HDD (e.g. degraded mode) the ICMP automatically starts with
the RAID recovery process. The red LED of the HDD which has to be rebuilt is blink ing.
This process takes about 200 GB per hour. Once the R AID is completed the red LED
turns off.
34 R5905722 ICMP 09/11/2016
To Next Page
Loading...
Need help?
General