K5902094 (451920611693) /02 MDSC-8232
38
3. Enter the Source shortkey submenu.
4. Enable/Disable the main source shortkey as desired and confirm.
5.4.4 OSD setting
5.4.4.1 OSD Horizontal Position
To adjust the OSD horizontal position
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
4. Select OSD Hor. Pos.
The command bar OSD Hor. Pos. is highlighted.
5. Set the OSD horizontal position as desired and confirm.
5.4.4.2 OSD Vertical Position
To adjust the OSD vertical position
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
4. Select OSD Ver. Pos.
The command bar OSD Ver. Pos. is highlighted.
5. Set the OSD vertical position as desired and confirm.
5.4.4.3 OSD Time-out
About OSD time-out
The OSD menu can automatically close after a certain time of inactivity after the last selection was made.
The available OSD time-out values for your display are:
• 10 Sec.
• 20 Sec.
• 30 Sec.
• 60 Sec.
• Disabled (=5 minutes)
To adjust the OSD time-out
1. Bring up the OSD main menu.
2. Navigate to the Configuration menu.
3. Enter the OSD setting submenu.
4. Select OSD Time-out
5. Select one of the available OSD time-out values and confirm.
5.4.5 Recall Profile
About recalling profiles
To recall a profile means to restore the default factory settings (Factory and X Ray profiles) or recall the user
defined profiles.
The available profiles to recall from your display are:
• Factory
• X Ray
• User 1
• User 2
• User 3
Advanced operation