Bard Sherlock 3CG - Service and Repair; Deleting Patient Information

32
Instructions For Use
12 Service and Repair
There is no periodic or preventative maintenance required for the Sherlock 3CG™ TCS.
For servicing information or to return your Sherlock 3CG™ TCS for repair, please contact Bard Access Systems' technical support hotline at (800) 443-3385.
Warning: Only qualified personnel should attempt to service this equipment. The Sherlock 3CG™ TCS contains static sensitive components and circuits.
Failure to observe proper static control procedures may result in damage to the system.
Warning: Opening or servicing the Sherlock 3CG™ TCS sensor by anyone other than Bard Access Systems' authorized service personnel will void the warranty
and may result in injury or equipment damage.
Warning: The following actions void the warranty of the Sherlock 3CG™ TCS and may result in injury or equipment damage.
- Opening or servicing the Sherlock 3CG™ TCS by anyone other than Bard Access Systems’ authorized service personnel.
- Removing system labels by anyone other than Bard Access Systems’ authorized service personnel.
Warning: Only Bard Access Systems’ authorized service personnel should attempt to service this equipment. The Sherlock 3CG™ TCS contains static
sensitive components and circuits. Failure to observe proper static control procedures may result in damage to the system.
13 Technical Specifications
13.1 Sherlock 3CG™ TCS Sensor and Display Operational and Storage Conditions
Operating Temperature: 10˚C to 38˚C (50˚F to 100˚F)
Storage Temperature: -18˚C to 40˚C (0˚F to 104˚F)
Operating Humidity: 5% to 85% non-condensing
Storage Humidity: 5% to 95% non-condensing
14 Disposal Information
To return the Sherlock 3CG™ TCS for end of life recycling, please contact your nearest Bard sales or distributor office in the country of purchase.
15 Deleting Patient Information
Note: This procedure will permanently delete all patient information from your system.
1. Select the Settings button.
2. Select the File Management button.
3. Select the Select All button.
4. Select the Delete button.