Milk intake
19
MAK 3003 Measuring system TIGER / LYNX Operating Instructions, Software version 2.35, BA 190130 (11.07.2022)
If there is no more milk flow, the pump switches off.
The intake can be ended in different ways depending on the configuration:
Manual: The intake is ended manually by the driver ( INTAKE END soft
key or Finished button on the remote control).
GPS Speed The intake is automatically ended via the measured speed
(termination also possible via the Finished button).
PTO signal The intake is ended by switching off the power-take-off (im-
portant: Only possible if signal is connected).
Automatic end
For the types "Optimate" and "V 6000", automatic ending can
be configured (Process Controlling/ Pumping settings/Auto.
ending: On).
The soft key INTAKE END or Finished button on the remote
control do not have to be pressed even when manually termi-
nated.
After finishing the intake, the intake record is printed.
You can stop the intake at any time with the button STOP on the controller or
the remote control.
If the pump switches off because the milk flow has been interrupted for a
short time, you can restart it by pressing the START button.
For further intakes, the supplier number must be entered again in each case.
Afterwards, the intake can take place as described.
To Next Page
Loading...
