Sampling
34
MAK 3003 Measuring system TIGER / LYNX Operating Instructions, Software version 2.35, BA 190130 (11.07.2022)
If no sample bottle with empty tag was detected, the intake cannot be started.
A corresponding message appears on the display.
The tag of the cur-
rent sample bottle
is already written.
Replace the sam-
ple bottle.
The tag could not
be recognised.
Check the position-
ing of the sample
bottle or replace
the sample bottle.
If an error occurs while writing to the tag, you can repeat the write operation
or cancel the operation. In this case, the intake is not started.
To Next Page
Loading...
