50-2 9424200996
Security BE1-11m
Figure 50-1. Login Screen
2. Enter the username and password of the administrator and then click the Log In button. The default
Administrator username is “A” and the default Password is “A”.
3. Only an administrator can modify usernames and passwords on the Username Setup screen (Figure
50-2). Complex usernames and passwords up to 16 characters in length are accepted. Acceptable
characters include uppercase letters, lowercase letters, numbers, and certain special characters.
BE1-11m firmware versions from 2.09.00 and beyond support at least
this set of characters in passwords:
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
a b c d e f g h I j k l m n o p q r s t u v w x y z
0 1 2 3 4 5 6 7 8 9
` ~ ! @ # $ % ^ & ( ) _ + - = { } [ ] \ : " ; ' < > ? . / ,
Figure 50-2. Username Setup Screen
4. In the left-hand column, highlight any username labeled NOT ASSIGNED or highlight a specific
username to change it.
5. On the right side of the screen, enter a username.
6. Enter a password for the user.
7. Re-enter the password to verify it.
8. Using Table 50-1 as a reference, enter the maximum access level allowed for the user.
9. Enter the number of days to expiration of the password or leave at default (0) for no expiration.
To Next Page
Loading...
Need help?
General
