Basler BE1-11m - Page 568

84-24 9424200996
Settings Calculation Examples BE1-11m
Motor Manufacturer Data
Motor manufacturer data should be reviewed before configuring the BE1-11m. Typical motor
manufacturer data is listed below.
● GENERAL
○ HP .....................................................................5000 HP
○ System Frequency ............................................60 Hz
○ Motor Rotation ..................................................1200 RPM
○ Bus Voltage ......................................................12 kV
○ Full-Load Amps (FLA, Synchronous) ...............205 A
○ Full-Voltage No-Load Stator Current in Sync ...128 A (no excitation)
○ Full-Voltage Line Current (95% Speed) ...........392 A (no excitation)
○ Maximum Locked Rotor Current (Max. LRA) ...755 A
○ Service Factor...................................................1.15
○ Power Factor Minimum .....................................0.90
○ Stator Insulation Class ......................................F (155°C per NEMA MG-1 Standard)
○ Ambient Temperature Rating ...........................40°C
○ Stator Temperature Rise ..................................76°C
○ Subtransient Reactance Xd”.............................0.368 pu, 4263 kVA base
○ Hot Safe Stall Time ...........................................8.5 seconds
○ Cold Safe Stall Time .........................................10.7 seconds
● FIELD
○ Excitation (Brushless) .......................................22 kW @ 51 Vdc
○ No Load Saturation
■ P.U. Line Volts 0.25 0.50 0.75 1.00 1.10 1.20 1.30
■ Field Amps 34.3 68.9 105.9 144.4 161.8 181.8 213.5 (motor)
0.3 0.7 1.1 1.3 1.5 1.6 1.9
(exciter)
○ Rated P.F. Excitation
■ P.U. Load 0.25 0.50 0.75 1.00 1.15
■ Field Amps 189.1 248.3 314.3 384.9 429.4 (motor)
1.7 2.2 2.9 3.5 4.6
(exciter)
● RTDs
○ Six Stator RTDs ................................................100 Ω, 3-wire element, platinum
○ Two Bearing RTDs ...........................................100 Ω, 3-wire element, platinum
○ One Ambient RTD ............................................100 Ω, 3-wire element, platinum
● STARTING
○ Minimum Starting Voltage ................................85%
○ Starting Performance
■ Starting Torque ....................................52%
■ Pull-In Torque ......................................115%
■ Pull-Out Torque ...................................151%
■ Inrush ...................................................368%
■ Pull-In Slip............................................5%
■ Accelerating Time ................................2.4 seconds
■ Motor WK
2
...........................................8391
■ Load WK
2
.............................................752