Baudoulin 6 M26.2 - Raw Water Pump

- 3/3 -
00342 - Edition 01 - September 11
Design
B200 - Cooling system
Non-contractual illustrations
Raw water pump (Ref. 15 53 168 0L)
This raw water pump is self-priming.
BEFORE each maintenance operation or AFTER each
draining,  ll the pump with water before start-up to facilitate
priming and avoid damaging the rotating seal.
Note: The inlet temperature of the raw water must be
between 10°C and 25°C to ensure proper engine operation.
For lower temperatures, a temperature regulation device
using a thermostatic valve must be installed.
The installation of a seawater  lter is recommended.
DT M26.2 03.04
DT 03.G03
DISCHARGE
SUCTION
Raw water pump
Bonding strip