To Next PageTo Next Page
Need help?Do you have a question about the Baudoulin 6 M26.2 and is the answer not in the manual?
Documents required for warranty claims, including installation and test sheets.
Severe continuous application with little or no engine load/speed variations.
Continuous application with frequent variations in engine speed and load.
Intermittent application with significant variations in engine speed and load.
Light application with significant variations in engine speed and load.
Explanation of symbols and general warnings used in the manual.
Defines safety symbols for personal protective equipment and hazardous situations.
Identifies common tools used with the engine, with corresponding symbols.
Guidelines and safety measures for using lifting devices for engine components.
Table listing essential specifications like bore, stroke, displacement, and ratings.
Diagram illustrating the engine firing order and pump injection order.
Imperative recommendations for using specific coolant for engine protection.
Specifies the total coolant capacity for the 6 M26.2 engine.
Details on the self-priming raw water pump, its operation, and recommended installation.
Guidance on selecting the correct oil type based on operating conditions and documentation.
Specifies the oil capacity for the 6 M26.2 engine's standard oil sump.
Description of the pressurized lubrication system, pump location, and oil cooling.
Details on the safety valves used to limit oil pressure, especially when the oil is cold.
Description of the control valve that maintains constant oil pressure and feeds cooler pumps.
Reference to technical documentation for fuel quality requirements.
Description of fuel flow from tank to injectors, including filters and pumps.
Details on how the turbocharger supplies and cools air to the engine cylinders.
Lists standard and optional electrical equipment, including control panels and cabinets.
Description of the primary and secondary screens, and their indicators.
Instructions for filling the engine oil, checking levels, and oil dipstick types.
Guidance on filling the coolant, coolant type recommendations, and level checks.
Pre-start checks including safety shields, moving parts, and stop circuits.
Recommended stabilized coolant temperature and monitoring procedures.
Advice on operating the engine under partial load to prevent wear and oil consumption.
List of daily checks to perform before engine startup.
List of daily checks to perform after engine startup.
Table detailing oil change intervals based on engine power and application.
List of M1 maintenance operations and their corresponding sheet references.
List of M2 maintenance operations and their corresponding sheet references.
List of M3 maintenance operations, including checks and belt tension.
List of items to check during M3 maintenance operations.
Procedure for checking and adjusting the alternator belt tension.
Specific checks for annual maintenance, covering alignment, tightness, and electrical systems.
Procedures for injector servicing, including rocker arm play and tube fastening checks.
Steps for replacing injector nozzles and checking thermostats.
Procedures for injector servicing, including rocker arm play and tube fastening checks.
Steps for replacing injector nozzles and checking thermostats.
Checks and coolant specifications for the engine cooling circuit during wintering.
Procedure for draining the raw water cooling circuit.
Steps for winterizing the engine oil circuit, including oil change and pre-lubrication.
Guidance on engine preservation and de-preservation for extended periods of non-use.
Instructions for operating and servicing pneumatic starter equipment.
General