00374 - Edition 01 - September 11
Maintenance
D400 - Maintenance operations
After 400 hours (P1 Service)
After 300 hours (P2 Service)
M1
Non-contractual illustrations
PR Catalogue
see chapters
03
04
05
Catalogue
P.R.
05
Bleed the water separator lter- option
Open and let the water in the lter run until the fuel starts to
ow.
Bleed the water separator
Oil lter replacement
(ref. 15 04 168 0C)
The cartridges must be replaced every time the oil is
changed. Before removing the oil lters, clean the
surrounding surfaces.
The disposable oil cartridges are located on the starboard
side of the engine. To replace, unscrew the cartridges using a
lter wrench.
b Clean the lter seal seat
on the engine.
b Smear the seal with
engine oil, do not use
grease.
b Screw the lter on
manually; do not use any
tools. Screw until the seal
makes contact and lock it
manually (an extra 3/4
turn).
b Check the oil level. Pre-grease the engine then check the
oil level. Top up if necessary. Check that the lter is leakproof.
Catalogue
P.R.
04
Environmental precaution
There are laws regarding environmental protection and the
disposal of waste and hydrocarbons. To ensure compliance
with environmental protection laws, consult your local
authorities who will advise you.
To Next Page
Loading...