MAINTENANCE
21 Batteries, electrical safety, software updates
21.1 General
The OccluSense
®
-System is basically maintenance-free.
However, the system must be calibrated once a day (if used) in the form of a function
test. If the function test runs successfully as described in chapters 11 and 12 "Safety
test & function test with test sensor", no maintenance is required. However, if errors
occur during the function test of the device, then there is probably a defect in the Occlu-
Sense
®
-System. In this case see chapter 19.
21.2 Replacing the batteries
CAUTION
Do not make any repairs or other changes to the system. •
The use of damaged and altered components is under the responsibility of the •
user.
In case of disregard any liability is excluded.
•
1. Loosen the screws of the battery compartment
cover using a Torx IP 6 screwdriver (included) and
remove the battery compartment cover.
The screws of the battery compartment cover are
"captive", i. e. they remain on the battery compart-
ment cover after opening.
76
To Next Page
Loading...