14.1.1 Switch off handheld
The handheld must be switched off to prevent unwanted operation. If the unit has been
turned on after removing it from the charging station, press and hold button 1 (pink) for
more than 2 seconds. The handheld then turns off (display off).
14.1.2 Insert sensor
The OccluSense
®
-Sensor is a horseshoe shaped pressure sensor. The sensor consists
of a printed electronic circuit inside featuring a sensibility of 256 pressure levels.
The red color coating on the outside enables the dentist to control the occlusion just
like with regular occlusion test materials. The total thickness of the sensor is only
60 microns which allows testing the dynamic occlusion as well.
The OccluSense
®
-Sensor is a single-use product, limited to one patient in the same
treatment only.
CAUTION
Only use sensors from undamaged original packagings! •
Observe expiry date!•
40
To Next Page
Loading...