Wait for the bypass fluid path of the Flow Diagram to light
up green.
1. Attach the dialysis fluid tubes to the dialyzer. Turn the dialyzer so
the blue end is up.
Single Needle: Verify that expansion chamber holder
is tilted.
2. Open clamp on arterial line.
3. Start the Blood pump to activate the assisted priming procedure.
The procedure will start with the fill up phase.
Make sure blue end is up and press Confirm.
CAMP/MG208/20-0006 AK 98 Independent Home Dialysis System 13
Priming the dialysis circuit (Section 4.2.7.3)
To Next Page
Loading...
