Baylis RFP-100A - DIRECTIONS FOR USE; READ INSTRUCTIONS FOR USE

To Next Page

To Previous Page

SECTION 7: DIRECTIONS FOR USE

7.1. READ INSTRUCTIONS FOR USE

Do not operate the Generator or BMC RF Device before thoroughly reading their

respective Instructions for Use. It is vital that the Instructions for Use for all the associated

equipment is read, understood, and followed properly.

7.2. CONNECT GENERATOR POWER CORD

Connect the Generator Power Cord plug into a properly grounded AC electrical outlet. To

ensure proper grounding, the Power Cord plug must be installed in an AC electrical wall

outlet designated “Hospital Grade” or “Hospital Only”. Never use an outlet without a

grounding connection.

Position the Generator for easy viewing of its front panel displays.

7.3. CONNECT FOOTSWITCH (OPTIONAL)

If the footswitch is to be used with Generator, it must be connected to the Generator rear

panel. Line up the four (4) pin footswitch connector with the footswitch connection. Rotate

the connector until it slides and clicks into place. A light tug on the cable can confirm that

the connector is properly seated.

To disconnect the footswitch from the Generator, grasp the connector housing and gently

pull it straight out of the receptacle. The connector housing slides backwards to disengage

the locking mechanism.

Never disconnect the footswitch by pulling on the cable cord.

7.4. CONNECT CONNECTOR CABLE

Verify the BMC Connector Cable model specified by the BMC RF Device Instructions for

Use. Connect the four (4) pin connector to the Connector Cable Connection on the

Generator front panel. The connector on the Connector Cable that connects to the

Generator is keyed. Gently line up the key while pushing in gently until the connector

clicks firmly into the receptacle.

To disconnect the Connector Cable from the Generator, grasp the connector housing and

gently pull it straight out of the receptacle. The connector housing slides backwards to

disengage the locking mechanism.

Never disconnect the Connector Cable by pulling on the cable cord.

Do not twist the connector of the BMC Connector Cable while inserting or removing it

from the Generator receptacle. Doing so may damage the pin connections.