BayTech DS2-RPC DS4-RPC - Password

DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
40
NOTE: This header may appear different depending on type of
module installed.
From the selection menu, select #1,
“Header,” followed by a carriage return <cr>.
The DS71 displays the current header status
and asks if you want to enable:
Header is......................... Disabled
Enable? (Y/N, CR for no change):
Type “Y“ for yes followed by <cr> if you
want to enable Header status. Type “N“ for
no followed by <cr> if you want to disable
Header. Enter <cr> for no change.
Password To change Password or Enable/Disable
Password upon login, select #2, “Password,”
from the selection menu, followed by <cr>.
Default Password is BTA, disabled. The
DS71 or DS71-MD2 module responds:
Change Password.....................1
Enable/Disable......................... 2
Exit.....................................…...X, CR
To change the current password, select #1,
“Change Password,” followed by <cr>. The
DS71 or DS71-MD2 module responds:
Enter New Password (1 - 8 char., CR to end):
Enter the new password up to 8 ASCII
characters followed by <cr>. The DS71 or
DS71-MD2 module stores the new password
in non-volatile memory and returns to the
selection menu.