DS-RPC OWNER’S MANUAL
APPENDIX E
__________________________________________________________________________________________
85
APPENDIX E
ASCII CHARACTER DEFINITION
ASCII CHARACTER DEFINITION
$BT Releases the module to receive the attention
character
$BTm Calls up a module (where m is a module number)
$BTm,p Calls up a module and port (where m is a module
number and p is a port number)
$BTB Locks the module in the binary mode. A “Break”
signal must be sent to clear this lock
$CONFIG Accesses the module configuration menu
$BTRESET Resets the unit. All communication will be lost if
attached via the modem
To Next Page
Loading...
Need help?
General
