BayTech DS2-RPC DS4-RPC - Access Character String; Menu Driven Selection

DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
50
Use the menu driven selection or the ASCII
character string method to reset the DS-
Series Unit:
Menu From the main menu, type “RU” to select
Driven “Reset Unit,” followed by <cr>. The DS71
Selection series module resets the unit and responds:
Reset Unit……
Allow approximately 10 seconds for the unit
to reset.
ASCII To reset the DS-Series Unit using the ASCII
Character character string method, send the following
String command: $BTRESET<cr>
NOTE: If you are locally connected through the serial port when the unit
is reset, the DS71 or DS71-MD2 module sends the header message and
returns to the Main Menu. A modem connection to the DS71-MD2
terminates when the unit resets.