EasyManua.ls Logo

BayTech DS2-RPC DS4-RPC User Manual

Default Icon
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #72 background image
DS-RPC OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
__________________________________________________________________________________________
64
The REBOOT n command will reboot or
reset equipment attached to corresponding
receptacle(s). When the command to
REBOOT (n) is sent from the RPC >
prompt, the DS-RPC powers “Off”
corresponding outlet(s) for approximately 10
seconds, then powers them up in sequence.
This command only works on outlets which
were “On” prior to the reboot.
RPC CONFIGURATION The DS-RPC configuration menu allows the
user to:
(1) set or change a password,
(2) customize the outlet name(s) to
identify equipment attached to
the RPC,
(3) enable or disable confirmation,
(4) enable or disable status menu.
The password is disabled from the factory
by making the password a carriage return. If
a password (other than a carriage return) is
set, the DS-RPC requires password entry
before allowing the user to operate the RPC
unit. The password feature is case
sensitive.
From the DS-RPC’s configuration menu, the
user can change any outlet name to outline a
unique set-up. Default outlet names are
Outlet 1, Outlet 2, Outlet 3, Outlet 4.
From the status menu’s DS-RPC > prompt,
type CONFIG. The following menu
appears:

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the BayTech DS2-RPC DS4-RPC and is the answer not in the manual?

BayTech DS2-RPC DS4-RPC Specifications

General IconGeneral
Input Voltage120V
Power over Ethernet (PoE)No
ManagedYes
Output Voltage120V
ProtocolsSNMP, HTTP, Telnet
PortsEthernet
MountingRack-mountable
Operating Temperature0°C to 40°C

Summary

Programmable Features of DS Modules

Installation and Cabling

Detailed Operation and Configuration

Connecting to the DS-RPC

Steps for establishing serial connections using EIA-232, internal, and external modems.

Operating the DS-RPC Interface

How to interact with the DS-RPC via its main menu, select devices, and use ASCII commands.

DS71 and DS71-MD2 Configuration

Detailed guide for configuring DS71/DS71-MD2 serial port, device names, passwords, and other settings.

DS74 Peripheral Module Configuration

Procedures for configuring the DS74 peripheral module's serial port and device names.

DS73TP Network Module Configuration

Comprehensive setup for DS73TP, including IP addresses, subnet, gateway, and DNS.

RPC Operation and Configuration

Controlling and Configuring Receptacles

Instructions for managing RPC receptacles and configuring RPC settings like passwords and names.

Related product manuals