BEC MX-210NP User Manual
Connection: Default set to Always on to keep an always-on 3G/4G-LTE connection.
Keep Alive: Select Yes to keep the 3G/4G-LTE connection always on
Keep Alive IP: Manually enter the Keep Alive IP Address to be used for ping operation to check
if the connection is still on.
Check Interval 5 x ___ Seconds: Default is set to 1 (5 seconds). Setup a timer to ping the
keep alive IP.
Default Route: Select Yes to use this interface as default route interface.
NAT: Select this option to Disabled/Enable the NAT (Network Address Translation) function. Enable
NAT to grant multiples devices in LAN to access to the Internet through a single WAN IP.
When router’s Internet configuration is finished successfully, you can go to the Status to check
connection information.
MTU: Maximum Transmission Unit. The size of the largest datagram (excluding media-specific
headers) an IP attempts to send through the interface. 0 means to use default MTU size, 1500byte.
Click Save to apply settings.
To Next Page
Loading...
