Beck IPC@CHIP Series

To Next Page

To Previous Page

IPC@CHIP DK41 / DK51

Getting Started V2.2

Now choose the CHIP.INI file on the IPC@CHIP and click “F4 Edit” to edit the file.

Paste the content of the Clipboard into the file after the IP section with CTRL+V.

Save the file and close the editor. In the dialog prompt that follows, you must then confirm that you

wish to upload the modified CHIP.INI file onto the IPC@CHIP. You then have to confirm that you wish

to overwrite the existing file.

You can close the FTP connection by clicking the “Disconnect” button once all files have been

transferred.

The DK40 must be restarted in order to activate the demo. To do this, switch the power off and on.

Beck IPC@CHIP Series - Page 13