Belden HIRSCHMANN GRS106 - Installation Procedures

Installation GRS105/GRS106
Release 01 11/2021
39
6Installation
The devices have been developed for practical application in a harsh
industrial environment.
On delivery, the device is ready for operation.
Perform the following work steps to install the device:
 Checking the package contents
 Installing the SD card (optional)
 Installing an SFP transceiver (optional)
 Installing the device
 Grounding the device
 Connecting the terminal blocks
 Connecting data cables
 Filling out the inscription label
Note: Note the safety instructions in “Requirements for connecting electrical
wires” on page 12.
6.1 Checking the package contents
 Check whether the package includes each item named in the section
“Scope of delivery” on page 73.
 Check the individual parts for transport damage.