Belden HIRSCHMANN GRS106 - Device Operation and Basic Settings; Operating the Device Safely

52
Installation GRS105/GRS106
Release 01 11/2021
7 Operating the device
Note: Note the safety instructions in “Requirements for connecting electrical
wires” on page 12.
Perform the following work steps:
 Plug the non-heating-appliance cables into the device and a socket with
an appropriate power source (supply voltage characteristic value G) and/
or screw the terminal blocks onto the device (supply voltage characteristic
value M or L).
You find the prescribed tightening torque in chapter:
“General technical data” on page 61
 Enable the supply voltage.
WARNING
ELECTRIC SHOCK
Connect only a supply voltage that corresponds to the type plate of your
device.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.