Installation GRS105/GRS106
Release
01
11/2021
41
6.3 Installing an SFP transceiver (optional)
Prerequisites:
Exclusively use Hirschmann SFP transceivers.
See “Accessories” on page 73.
Figure 13: Installing SFP transceivers: Installation sequence
Perform the following work steps:
Take the SFP transceiver out of the transport packaging (1).
Remove the protection cap from the SFP transceiver (2).
Push the SFP transceiver with the lock closed into the slot until it latches
in (3).
6.4 Installing the device
WARNING
ELECTRIC SHOCK
Exclusively install this device in a switch cabinet or in a restricted access
location according to EN 62368-1, to which maintenance staff have
exclusive access.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
3
To Next Page
Loading...
