BHT-430-MM-2
5-00-00
Page 64 Rev. 15 26 JAN 2007
Chapter 67 3. Measure the amount of minimum friction on the cyclic stick,
collective stick and the tail rotor pedals. Adjust the minimum
friction as necessary. (F2)
Chapter 96 4. Examine the condition of the electrical and avionics
components in the nose compartment. Make sure they are
correctly installed. Examine the electrical harnesses and cables
for frayed wires and loose or broken clamps and fasteners.
Chapter 52 5. Examine the nose compartment door for damage. Make
sure it latches correctly. (F1/F2)
Chapter 95 6. Examine the pitot tubes. Make sure they are correctly
attached. (F1/F2)
Chapter 52 7. Examine the crew doors, passenger doors and baggage
compartment doors for damage or corrosion. Examine the
positive locking mechanisms. Examine the door seals for tears
or separations. Make sure the doors are correctly attached to
the airframe structure. (F1/F2/F3/F4)
Chapter 25 8. Examine the seat cushions and seat backs for tears and
deterioration. Make sure they are correctly attached. (F1/F2/F3/
F4)
Chapter 25 9. Examine the seat assemblies to make sure they are
correctly attached to airframe structure. (F1/F2/F3/F4)
Chapter 25 10. Examine the crew seat attenuation indicators. (F1/F2)
Chapter 25 11. Examine the safety belts and shoulder harnesses for
deterioration. Make sure they are correctly attached to the
airframe structure. (F1/F2/F3/F4)
Chapter 26 12. Examine the cabin fire extinguisher for damage or
corrosion. Examine the operation of the quick opening clamp.
Make sure the fire extinguisher is fully charged. (F1/F2)
Chapter 11 and
BHT-430-FM-1
13. Examine the placards and instrument panel decals. Make
sure they are clear and legible. (F1/F2)
SCHEDULED INSPECTIONS
5-24. PROGRESSIVE INSPECTION — EVENT 9 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER
To Next Page
Loading...
