Bell 8084150 - Message Alert Tone; Voice Guide; Using Your Built-In Answering System

3636
Message alert tone
When the message alert tone is set to
ON, and there is at least one new message, the
telephone base will beep every 10 seconds. The
message alert tone is preset to OFF.
1. Press MENU when the handset is not in use.
2. Press
or to scroll to Answering sys, then
press SELECT.
3. Press
or to scroll to Ans sys setup, then
press SELECT.
4. Press
or to scroll to Msg alert tone, then
press SELECT.
5. Press
or to choose ON or OFF.
6. Press SELECT to save. You will hear a
conrmation tone.
NOTES:
• The answering system must be turned ON for
the message alert tone to be functional
• Press any key on the telephone base (except
FIND HANDSET) to temporarily silence the
message-alert tone
Voice guide
This feature is an alternative way for you to do
the basic setup of the answering system. You
can follow the voice guide to record your own
announcement, set the number of rings and the
message alert tone.
1. Press MENU when the handset is not in use.
2. Press
or to scroll to Answering sys, then
press SELECT.
3. Press
or to scroll to Voice guide, then press
SELECT. You will hear the voice prompt “Hello!
This voice guide will assist you with the basic
setup of your answering system.”
4. Setup your answering system by inputting
designated numbers as instructed in the
voice guide.
NOTES:
• You can press CANCEL to quit the voice guide at
anytime.
• If the system does not receive any input, it will
announce “Sorry, I still have not received any input.
If you want to restart the voice guide, please enter
the menu and select Voice guide under Answering
system. Goodbye.”
Using your built-in
answering system
New message indication
When there are new answering system messages,
the message window on the telephone base will
ash and XX new messages will display on
the handset.