Bend-Tech Dragon A400 - Cable Connections and Safety Guards

29Bend-Tech Dragon A400
Powered Gate Retrot Guide
Installation Guide
02
Cable Connections
To connect the C Axis Drive Motor to the Control Box, the Installer will need to route the motor
cable from the Powered Gate Driver Box to the C Axis Drive Motor. Route the C Axis Homing
Sensor cable to the Control Box. Connect to the socket labeled “Gate” located just under the
cooling fan at the top of the Control Box.
Bend-Tech recommends using cable ties, or zip ties, to route the Powered Gate cables along
the existing cables leading to the Head of the machine. Connect the cables and tighten the
ferrules securely by hand.
! Caution !
Do not use tools to tighten cable connections.
! Caution !
Ensure the machine is powered down when connecting or disconnecting motor
cables.