What to do if Bender EDS460 shows a display device error?
If your Bender Diagnostic Equipment displays a device error, have the device information ready when you contact support by telephone for assistance.
What does error code 72 mean on Bender Diagnostic Equipment?
Error code 72 on Bender Diagnostic Equipment indicates a fault with the RS-485 interface of the BMS.
What does error code 71 mean on Bender EDS460?
Error code 71 on Bender Diagnostic Equipment indicates that no master is available on the BMS interface, or the master hasn't been queried for five minutes.
What does error code 13 mean on Bender Diagnostic Equipment?
Error code 13 on Bender Diagnostic Equipment indicates a hardware error after performing a self-test.
What causes error code 12 on Bender EDS460 Diagnostic Equipment?
Error code 12 on Bender Diagnostic Equipment is caused by a wrong measurement p.c.b. or incorrect mounting.
Why does my Bender EDS460 Diagnostic Equipment show error code 11?
Error code 11 on Bender Diagnostic Equipment means that the device is not calibrated.
What does error code 4 mean on Bender EDS460?
Error code 4 on Bender Diagnostic Equipment indicates that no boot loader is available.
What causes error code 2 on Bender EDS460?
Error code 2 on Bender Diagnostic Equipment is caused by a fault in the data memory (RAM).
What causes error code 1 on Bender EDS460 Diagnostic Equipment?
Error code 1 on Bender Diagnostic Equipment is related to a fault in the parameter memory (EEP- ROM/FLASH).
General| Supply voltage | 24…240 V AC/DC |
|---|---|
| Response values | 0.03…3 A |
| Measurement Range | 0.03…3 A |
| Voltage Range | 24…240 V AC/DC |
| Frequency Range | 50/60 Hz |
| Power Supply | 24…240 V AC/DC |
To Next Page
