Safety instructions
10
TGH1394en/05.2007
Up to 12 measuring current transformers can be connected to one
EDS.... Up to 90 EDS... evaluators can be connected via a BMS bus (RS-
485 interface with BMS protocol), thereby up to 1080 measuring chan-
nels (sub-circuits) can be monitored. The scanning time for all channels
is approximately 4…10 s.
The individual parameterization, necessary to adjust the evaluator to the
existing system and utilization conditions, must be carried out at the
place of utilization in order to meet the requirements laid down in the
standards.
Please take note of the limits for the application area specified in the
technical data. Any other use, or use which goes beyond the foregoing
is deemed to be use other than for the intended purpose.
Use for the intended purpose also includes:
The observation of all information in this operating manual.
and the compliance with test intervals.
2.2 Qualified personnel
Only suitably qualified personnel may work on BENDER devices. Per-
sonnel who are familiar with the assembly, commissioning and opera-
tion of the equipment and have undergone appropriate training are
considered qualified. Such personnel must have read this manual and
understood all instructions relating to safety.
2.3 Safety information
BENDER devices are built in accordance with the state of the art and
accepted rules in respect of technical safety. Nevertheless, the use of
such devices may introduce risks to the life and limb of the user or third
parties and/or result in damage to BENDER devices or other property.
Only use BENDER devices:
– for the purpose for which it is intended;
To Next Page
Loading...