Operation
47
TGH1394en/05.2007
6.6.3 Menu 3: Settings
The following menu items are available for configuring the EDS...:
Menu item Function Page
Exit Exit Settings -
1.General Configure the fault memory, trigger, rated
frequency and type of system.
48
2.Channel Configure the following in respect of each
measuring channel: Response value, meas-
uring transformer type, response delay,
delay on release, measuring transformer
monitoring, filters for systems with convert-
ers, and alarm when the residual current has
been exceeded.
49
3.Relay Set the mode of operation and type of fault
that you wish to cause a switching opera-
tion for common alarm relay.
53
4.History Erasing the history memory 54
5.Language
Select the language for menu and alarm texts.
54
6.Interface Configure the BMS bus address of the EDS... 54
7.Alarm-
addresses
Setting of bus addresses for devices whose
alarm messages are to be displayed on this
EDS...-D.
54
8.Clock Configure the time, date, date format and
summer time changeover.
55
9.Password Changing and activating the password. 56
10.Factory
setting
Resets every setting to its factory setting. 56
11.Service For Bender service staff only. 56
To Next Page
Loading...