Operation
62
TGH1394en/05.2007
The "Settings" menu displays the following settings:
6.6.6 Menu 6: Info
This menu displays standard information on the EDS...-D (for details re-
fer to "Displaying standard information" on page 39).
Menu item Function Page
Exit Exit Settings -
1.General Configure the fault memory, trigger, rated
frequency and type of system.
48
2.Channel Configure the following in respect of each
measuring channel: Response value, meas-
uring transformer type, response delay,
delay on release, measuring transformer
monitoring, filters for systems with convert-
ers, and alarm when the residual current has
been exceeded.
49
3.Relay Set the mode of operation and type of fault
that you wish to cause a switching opera-
tion for common alarm relay.
53
4.Factory
setting
Resets every setting to its factory setting. 56
5.Service For Bender service staff only. 56
To Next Page
Loading...