Bender EDS460 - Menu 4: Control; Control Menu 1: TEST; Control Menu 2: RESET; Control Menu 3: Test Communication

Operation
57
TGH1394en/05.2007
6.6.4 Menu 4: Control
This menu offers various options for controlling the EDS:
6.6.4.1 Control menu 1: TEST
Call up a test (see also "Carrying out a test" on page 37). To prevent this
function being carried out inadvertently, the operator must once again
confirm this entry.
6.6.4.2 Control menu 2: RESET
Call up a reset (see also "Resetting saved alarm messages (RESET)" on
page 38). To prevent this function being carried out inadvertently, the
operator must once again confirm this entry.
6.6.4.3 Control menu 3: Test communication
This function enables you to test the communication between the EDS...
and other BMS equipment. This involves the EDS... sending an alarm
message via the BMS bus until the "Test communication" function is ex-
ited. A connected evaluation device (IRDH575, PRC1470, MK2430,
FTC470...) must process this alarm. Select a channel for this alarm mes-
sage.
Exit Exit Settings
1.TEST Call up a test
2.RESET Initiate a reset (see "Resetting saved alarm mes-
sages (RESET)" on page 38")
3.Test
communication
Test communication between the EDS... and
other BMS equipment.