Operation
40
TGH1394en/05.2007
6.4 Setting the EDS...-L
EDS...-L has a 7-segment LED display only. It can be operated and set
via an EDS…-D or via the following devices: IRDH575 (V1.5 or higher),
PRC1470, MK2430 or FTC470XET. Only the BMS bus address can be set
directly on the EDS...-L.
The following functions and settings are
not
included in the EDS...-L
:
Setting the BMS bus address of the EDS...-L
1. Press the "SET" key for approximately two seconds to open the main
menu. The BMS bus address flashes.
2. Use the "c, d" arrow keys to select the required address.
3. Press the "↵" enter key to confirm this setting.
4. If you wish to exit the setting without making a change, press the "ESC"
key.
6.5 Operating and setting the EDS...-D
This chapter describes the EDS...-D menu mode.
The EDS...-L only has some of these functions available (see "Setting the
EDS...-L" on page 40). This also applies if an EDS...-D is used to operate
and set an EDS...-L.
– Displaying standard
information
– Time of day/ date
– Language – Interface menu
– History memory – Password
To Next Page
Loading...