Bender EDS460 - Carrying out a Test

Operation
37
TGH1394en/05.2007
 EDS...-L: The alarm LED of the affected channel lights or flashes in case
of a device error.
6.3.3 Carrying out a test
A test serves to check the device function (hardware components) of the
EDS. A test can be called in the following ways:
 press the "TEST"button on the front panel of the EDS.. ,
 press an external TEST button connected to the EDS... ,
 send a TEST command via the BMS bus.
 EDS...-D only: Call the "TEST" function in the Control menu.
The EDS... responds as follows:
 LED "ALARM 1" and LED "ALARM 2" light.
 All alarm relays switch (function can be deactivated, see page 53).
 An alarm message is being sent to the BMS bus.
 An entry is made in the history memory with the suffix "TEST".
 EDS...-D: An alarm message is shown on the display.
 EDS...-L: All alarm LEDs light up.
 EDS...-D: The progress of the test is shown on the display.
The EDS...-D will now display the maximum measured value that
can be detected (provided that the measuring channel is function-
ing correctly). Press the "T" arrow key several times to show that
the other channels are functioning correctly.
Auto test