Operation
42
EDS460-490_D00085_01_M_XXEN/02.2016
6.4 Setting the EDS…-L
EDS…-L has a 7-segment LED display only. It can be operated and set via an
EDS…-D or via the following devices: IRDH575 (V1.5 or higher), MK800 or
FTC4…XET. Only the BMS bus address can be set directly on the EDS…-L.
The following functions and settings are
not
included in the EDS…-L
:
Setting the BMS bus address of the EDS…-L
1. Press the "SET" button for approximately two seconds to open the
main menu. The BMS bus address flashes.
2. Use the arrow buttons ", " to select the required address.
3. Press the Enter button "↵" to confirm this setting.
4. If you wish to exit the setting without making a change, press the "ESC"
button.
6.5 Operating and setting the EDS…-D
This chapter describes the EDS…-D menu mode.
The EDS…-L only has some of these functions available (see „Setting the
EDS…-L“ on page 42). This also applies if an EDS…-D is used to operate and
set an EDS…-L.
– Displaying standard
information
– Time of day/ date
– Language – Interface menu
– History memory – Password
To Next Page
Loading...