Bender EDS460 - Settings Menu 10: Factory Settings; Settings Menu 11: Service; Menu 4: Control; Control Menu 1: TEST

Operation
59
EDS460-490_D00085_01_M_XXEN/02.2016
6.6.3.10 Settings menu 10: Factory settings
Resets every setting to its factory setting. Factory settings are given in paren-
theses "( )*" in the technical data.
6.6.3.11 Settings menu 11: Service
This menu is intended for Bender service employees only.
6.6.4 Menu 4: Control
This menu offers various options for controlling the EDS:
6.6.4.1 Control menu 1: TEST
Call up a test (see also „Carrying out a test“ on page 39). To prevent this func-
tion being carried out inadvertently, the operator must once again confirm
this entry.
6.6.4.2 Control menu 2: RESET
Call up a reset (see also „Resetting saved alarm messages (RESET)“ on page
40). To prevent this function being carried out inadvertently, the operator
must once again confirm this entry.
6.6.4.3 Control menu 3: Test communication
This function enables you to test the communication between the EDS… and
other BMS devices. This involves the EDS… sending an alarm message via the
BMS bus until the "Test communication" function is exited.
A connected evaluation device (IRDH575, MK800, COM460IP, FTC470…) must
process this alarm. Select a channel for this alarm message.
Exit Exit Settings
1.TEST Call up a test
2.RESET Initiate a reset
3.Test
communication
Test communication between the EDS… and
other BMS devices.